Life Fitness Model TR91/95/97 Series Treadmills
How To… Install The Roller Guard Bracket Kit
Tools required: Hex key wrench set, socket and ratchet set, drillbit set, drill, file,
and Phillips screwdriver
Kit # GK58-00002-0008
1. Turn the unit power OFF at the ON/OFF switch, and then
Rear Roller
Welded Guard
Tab
unplug the line cord at the wall outlet.
2. Remove the REAR ROLLER GUARDS.
3. Remove tension bolts from REAR ROLLER.
4. Remove the REAR ROLLER.
5. Insert the Treadmill Model appropriate TEMPLATE into
user left rear roller channel and mark hole locations on the
FRAME. Flip the template and repeat for the user right
rear roller channel.
Rear
Roller
Tension
Bolts
6. Drill a 0.154 hole at each of the four marked locations.
7. Install a GROMMET into each ROLLER GUARD
BRACKET.
8. Install each ROLLER GUARD BRACKET using two
supplied short screws.
Grommet
Rear Roller
Guards
Note: It may be necessary to file down any weld material that
would prevent the ROLLER GUARD BRACKET from being
mounted flush to the frame.
9. Re-install the REAR ROLLER. Using the supplied long
screws, re-install the REAR ROLLER GUARDS making
sure the striding belt is properly adjusted and tensioned.
Refer to service manual “HOW TO…Replace Striding Belt”
for proper belt adjustment and tensioning.
Bracket
Self-Tapping
Screws
M051-00K58-A026
|
Lennox Hearth Stove H7638 User Manual
LG Electronics Drums LGENBOX 01 User Manual
Life Fitness Home Gym X9 User Manual
Linksys Network Router BEFSR81 User Manual
Linksys Stereo System KWHA700 User Manual
Marvel Industries Games 77237 77184 User Manual
M Audio Computer Hardware 1010LT User Manual
MB QUART Car Stereo System PSD 316 User Manual
Metz Camcorder 28 AF 4 C User Manual
Meyer Sound Stereo System MSPN 2703311201 User Manual